EXHAUST GAS PRESSURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2]


id0140z7443600


Exhaust Gas Pressure Sensor No.1 Removal/Installation

Warning
•  A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

3.  Remove the insulator. (See TIMING CHAIN REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

4.  Disconnect the exhaust gas pressure sensor No.1 connector.

5.  Remove the exhaust gas pressure sensor No.1 installation bolt.

ac5jjw00005988

6.  Remove the bracket installation bolt.

ac5jjw00005989

7.  Remove the exhaust gas pressure sensor No.1. (See Exhaust Gas Pressure Sensor No.1 Installation Note.)

ac5wzw00005481

8.  Install in the reverse order of removal.


Exhaust Gas Pressure Sensor No.1 Installation Note

Caution
•  Verify that the clip is installed to the specified position as shown in figure, or it will cause exhaust gas leakage and damage to exhaust gas pressure sensor No.1.

1.  Install the exhaust gas pressure sensor No.1 shown in the figure.

ac5wzw00008492


Operation After Replacing Exhaust Gas Pressure Sensor No.2

1.  If the exhaust gas pressure sensor No.2 is replaced, perform the following procedure.

STEP

ACTION

PAGE/CONDITION

1
Perform the KOEO self test.
2
Perform the KOER self test.


Exhaust Gas Pressure Sensor No.2 Removal/Installation

Warning
•  A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

3.  Remove the insulator. (See TIMING CHAIN REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

4.  Disconnect the exhaust gas pressure sensor No.2 connector.

5.  Remove the exhaust gas pressure sensor No.2. (See Exhaust Gas Pressure Sensor No.2 Installation Note.)

ac5wzw00005483

6.  Install in the reverse order of removal.

7.  Perform operation after replacing exhaust gas pressure sensor No.2. (See Operation After Replacing Exhaust Gas Pressure Sensor No.2.)


Exhaust Gas Pressure Sensor No.2 Installation Note

1.  Install the exhaust gas pressure sensor No.2 shown in the figure.

ac5wzw00005484